For this week's session (11/1/17), we began by huddling up and recapping where we're all supposed to be in terms of our progress. Then we were able to split up into our sub-teams to continue working on our project.
Some of our ordered parts came in already so we were able to begin our rapid prototyping. We were all spending time just getting our new parts set up and working. I started to assemble the breadboard set-up and began wiring the servo and the start/terminate buttons, as well as assist Coby in getting the soldering of the motor drivers done. Coby has a de-soldering tool at home so he went on to continue the progress there.
This week I will continue learning about the XBee communication with the Arduino.
No comments:
Post a Comment